Ubiquiti Rocket AC 5.8GHz - PTMP AirPrism
- AirPrism HSR superheterodyne active filter
- Ideal for high subscriber density, collocated access points
- 10/20/30/40MHz channel sizes 5470-5875MHz
- Up to 330Mbps with 802.11ac MCS-9 (256QAM, 5/6 coding)
- Up to 500mW output power (27dBm)
- 10/100/GigEth RJ-45 Input
- 2x RP-SMA Female antenna connections
- Radio only (external antenna required)
- 24VDC POE Injector (Passive) & 240V AC Adapter included.
Ubiquiti Networks has designed the first airMAX® ac radios with high performance and ease of installation in mind. You have the freedom to deploy the Rocket™ ac anywhere in the world, and it allows for a high degree of flexibility in configuring channel bandwidths (subject to local country regulations). To enhance airMAX ac performance, Ubiquiti Networks introduces our patented airPrism™ technology, which is featured on the R5AC-PTP.
High data rates require a high Signal-to-Noise Ratio (SNR), which is challenging to achieve, especially in noisy, high-density areas. Integrated into Ubiquiti’s custom silicon, airPrism technology creates a high SNR by isolating signals within the operating channel and rejecting interference using specialized circuitry, the High-Selectivity Receiver (HSR).
Depending on the operating mode, available channel widths may include 10, 20, 30, and/or 40 MHz. Theoretically APs operate on different channels; however, because of the wider channel bandwidths, there can be overlap in spectrum usage. airPrism technology removes up to an additional 30+ dB of adjacent channel interference through the active filtering design, so an airMAX ac AP with airPrism technology can provide significantly greater performance than a typical AP.
Facilitates AP Co-Location
Co-location is vital in many scenarios. For example, a WISP may have limited tower space, so it must co-locate all APs within that allotted footprint. Shielding and other means can lessen interference but may be impractical. By deploying airMAX ac APs with airPrism technology, you can co-locate APs and enhance the overall performance of your wireless network. Number of APs: 8 = 40 MHz Channel Width 16 = 20 MHz Channel Width
High Speed Network Sharing
This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work. Management of the Ubiquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface. The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the Rocket, and the other into the PoE Injector (which is plugged into AC power). This allows one cable to both power the unit and also carry network traffic. We recommend using Cat6 Outdoor UV Shielded Cable with this unit.