Cel Fi Go Repeater Kit for Telstra – Magnetic Mount - Temporary Setups


Key Features


  • Complete package with a 5dBi Magnetic Base Antenna, cabling, repeater and small stick on Antenna for the internal distribution

  • Full service for up to 20 Telstra mobile phones or modems

  • 4Gx(700MHz) or Next G(850MHz) frequency support (manual selection)

  • Suitable for Telstra, Boost, and Aldi Mobile networks

  • Currently Australia's only legal mobile phone repeater system.




  • The Cel Fi Go Repeater for the Telstra network is a convenient way to boost and distribute a 3G/4G mobile signal within your vehicle including cars, 4WD & trucks

  • Installing this device in your vehicle can improve the reliability of phone calls, text messages, and increase 3G or 4G or 4GX services

  • This is a complete repeater system designed to provide indoor coverage

  • Despite its compact size (just over 30cm) this antenna performs exceptionally well in a range of different areas, from hilly to flat areas, city to country, and can be used to give a boost to areas with low-moderate signal.

  • Bear in mind this is a ground dependant Antenna, so it will need to sit on a Metal surface for optimal performance

  • The Magnetic Antenna is connected to the repeater via a 3m LCU195 tail with an adapted fitting to connect directly onto the Cel Fi Go’s input connector. A Small Stick On T-Bar Antenna is then connected to the Cel Fi Go’s output in order to disburse the captured signal

  • The repeater provides enough boost to entirely cover the internal of the vehicle.

  • In order to avoid potential interference between the two antennas, they need to be isolated as far apart as possible. We generally install the Cel Fi Go under the seat and the output antenna towards the back of the vehicle

  • If there is no isolation between the Antennas the Repeater setup will not function


Why is it legal?


  • Many mobile service providers do not support personal repeaters on their network. This is due to the interference they can cause when connected to the network, or when they are setup incorrectly

  • The Cel-Fi system is the only personal repeater that is widely approved by carriers in Australia

  • The Cel Fi Go is different to a standard repeater - it is designed to provide maximum coverage, be network friendly, and is easily installed by the end user. It does by:

    • continuously monitoring power levels of the cell tower it is connected to, and constantly adjusting its output power to suit

    • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band

    • giving the service provider the ability to shut down the repeater remotely if needed, using a signal from the base station

    • not interfering with the carrier’s network or other users on the network

    • having a unique installation process to eliminate feedback into the mobile network.


A heads up!


  • This repeater unit is designed to provide 3G or 4G/x services to mobile devices - it cannot produce both networks concurrently. 



Shipping Weight 6.0000kg
Shipping Width 0.300m
Shipping Height 0.560m
Shipping Length 0.200m
Shipping Cubic 0.033600000m3