Ubiquiti NanoStation M5 LOCO (5.8GHz) Point-to-Point Wireless

 

Key Features

 

  • Connect two remote locations on the one network

  • Share Internet connection between buildings, remote sites, etc.

  • Up to 200mW output power, 2x2 MIMO operation, 100Mbps

  • Integrated AirOS web software for controlling power, bridge/AP mode, etc.

  • Two units required for wireless bridge

  • Includes POE injector and 240V AC adaptor.

 

What is a NanoStation LOCO?

 

  • The Loco is a more cost effective version of the Ubiquiti NanoStation - it is a lower power unit designed for shorter distances

  • There are some features (such as Dual-Ethernet capabilities) that the LOCO version doesn't have, so if in doubt, please read through the specification sheet at the bottom of the page.

 

High Speed Point-to-Point Networking

 

  • Forget Ethernet cable, the Ubiquiti NanoStation LOCO is ideal for bridging networks or sharing broadband between buildings

  • To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location

  • Face both units so they point towards each other and the link is established. Simple!

  • This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work

  • Management of the Ubiquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface.



 
CD2409 attached to a NetComm NP730 outdoor Access Point providing WiFi coverage for "A Day on the Green" rock festival.
WiFi was bridged over 800m using Ubiquiti NanoStation point-to-point 5.8GHz bridges.

 

Ready to Install

 

  • This unit has all networking hardware and surge protection integrated and is completely weatherproof for permanent installation in even the toughest environments

  • Signal strength indicators allow for quick and easy alignment

  • For best performance the unit should be roof mounted, high and clear of obstructions, via its integrated pole mounting bracket

  • The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation, and the other into the PoE Injector (which is plugged into AC power)

  • This allows one cable to power the unit and also carry network traffic

  • We recommend using Cat6 Outdoor UV Shielded Cable with this unit.

 

Read More

 

 

Setup Guides (Click Images)
long range wifi client using ubiquiti nano as antennawide area wifi access point setup ubiquiti

 

 

direct point to point wireless bridge ubiquiti nanostation m2 m5point to multipoint wireless bridge ubiquiti nano station access point WDS

 

 

point to point link with wifi access ubiquiti airos

 

(LOCOM5)

SKU LOCOM5
Brand Ubiquiti
Shipping Weight 0.0450kg
Shipping Width 0.200m
Shipping Height 0.200m
Shipping Length 0.200m
Shipping Cubic 0.008000m3