Cel Fi Go Repeater Kit designed for Outback or Remote Areas

 

Key Features

 

  • Complete package with an external antenna, cabling, repeater & ceiling antenna

  • Provides full service for up to 20 Telstra mobile phones or modems

  • 4Gx(700MHz) or Next G(850MHz) frequency support (manual selection)

  • Suitable for Telstra, Boost, and Aldi Mobile networks

  • Currently Australia's only legal mobile phone repeater system.

 

Usage

 

  • The Cel Fi Go Repeater for the Telstra network is a convenient solution for those experiencing poor phone coverage inside the house or office

  • This is a complete repeater system designed for indoor coverage

  • Installing this device in your home can improve the reliability of phone calls, text messages, and increase 3G or 4G or 4GX services

  • The dual-band 700-850MHz Yagi antenna is ideal for rural areas where long transmission distances result in low signal - typically with the tower within 70-90km from your location

  • As this antenna does not operate on 1800MHz 4G, this kit is not suitable for urban areas

  • The repeater provides enough boost to create a 30-60m radius of coverage within normal home or office environments, with up to an impressive 100m radius in open areas such as supermarkets or farms, as reported by our customers

  • Like all wireless systems, the coverage area is reduced by the signal travelling through thick walls or floors, so the actual coverage area will vary depending on your unique situation

  • The design of this repeater allows for greater flexibility - we can split the output signal across multiple antennas and even daisy chain the set up to another location

  • Please contact one of our sales team to discuss the potential options further.

 

A heads up!

 

  • This repeater unit is designed to provide 3G or 4G/x services to mobile devices, it cannot produce both networks concurrently. 

 

Installation

 

  • The dual band Yagi antenna is connected to the repeater via a run of LCU400 cable with an SMA fitting, which allows the cable to directly connect to the Cel Fi Go’s input connector - from there, a smaller grade of LCU195 Cable is connected to the Cel Fi Go’s output, which is run to the location where you wish to install the ceiling mounted antenna.

 

Similar kits

 

  • We provide similar kits for suburban and metro areas suffering from poor coverage indoors despite good signal outdoors, and kits for hilly and regional areas. 

 

Performance on 4G/4GX Internet

 

  • To provide the best and fastest Internet connection possible, a proper MIMO external antenna should be connected into a dedicated 3G/4G modem

  • Typical speeds through the repeater unit are around 25-30% of a dedicated modem.

 

Why is it legal?

 

  • Many mobile service providers do not support personal repeaters on their network, because of the interference they can cause when connected to the network, or when they are setup incorrectly

  • The Cel-Fi system is the only personal repeater that is widely approved by carriers in Australia

  • The Cel Fi Go is different to a standard repeater as it was designed to provide maximum coverage, is network friendly and easily installed. It does this by:

    • continuously monitoring power levels of the cell tower it is connected to, constantly adjusting its output power to suit the levels

    • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band

    • giving the service provider the ability to shut down the repeater remotely if needed, using a signal from the base station

    • not interfering with the carrier’s network or other users on the network

    • having a unique installation process to eliminate feedback into the mobile network.

 

(CFG-T-O)

SKU CFG-T-O
Shipping Weight 11.0000kg
Shipping Width 2.400m
Shipping Height 0.420m
Shipping Length 0.460m
Shipping Cubic 0.463680000m3