Cel Fi Go Repeater Kit designed for Outback or Remote Areas


Key Features


  • Complete package with an external antenna, cabling, repeater & ceiling antenna

  • Full service for up to 20 Telstra mobile phones or modems

  • 4Gx(700MHz) or Next G(850MHz) frequency support (manual selection)

  • Suitable for Telstra, Boost, and Aldi Mobile networks

  • Currently Australia's only legal mobile phone repeater system.




  • The Cel Fi Go Repeater for the Telstra network is a convenient solution for those experiencing poor phone coverage inside the house or office

  • Installing this device in your home can improve the reliability of phone calls, text messages, and increase 3G or 4G or 4GX services

  • This is a complete repeater system designed for indoor coverage

  • The dual-band 700-850MHz Yagi antenna is ideal for rural areas where long transmission distances result in low signal - typically with the tower within 70-90km from your location

  • The dual band Yagi Antenna is connected to the repeater via a run of LCU400 cable with an SMA fitting, which allows the cable to directly connect to the Cel Fi Go’s input connector - from there, a smaller grade of LCU195 Cable is connected to the Cel Fi Go’s output, which is run to the location where you wish to install the ceiling mounted antenna

  • As this antenna does not operate on 1800MHz 4G, this kit is not suitable for urban areas

  • The repeater provides enough boost to create a 30-60m radius of coverage within normal home or office environments, with up to an impressive 100m radius in open areas such as supermarkets or farms, as reported by our customers

  • Like all wireless systems, the coverage area is reduced by the signal travelling through thick walls or floors, so the actual coverage area will vary depending on your unique situation

  • The design of this repeater allows for greater flexibility - we can split the output signal across multiple antennas and even daisy chain the set up to another location. Please don’t hesitate to contact one of our sales team to discuss the potential options further.

  • This repeater unit is designed to provide 3G or 4G/x services to mobile devices, it cannot produce both networks concurrently. 


Similar kits

  • We also provide similar kits for suburban and metro areas suffering from poor coverage indoors despite good signal outdoors, and kits for hilly and regional areas. 


Performance on 4G/4GX Internet

  • To provide the best possible and fastest Internet connection, a proper MIMO external antenna should be connected into a dedicated 3G/4G modem

  • Typical speeds through the repeater unit are around 25-30% of a dedicated modem.


Why is it legal?

  • Many mobile service providers do not support personal repeaters on their network. This is due to the interference they can cause when connected to the network, or when they are setup incorrectly

  • The Cel-Fi system is the only personal repeater that is widely approved by carriers in Australia

  • The Cel Fi Go is very different to a standard repeater as it was designed to provide maximum coverage, be network friendly and easily installed by the end user. It does this in several ways by:

    • continuously monitoring power levels of the cell tower it is connected to, constantly adjusting its output power to suit

    • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band

    • giving the service provider the ability to shut down the repeater remotely if needed, using a signal from the base station

    • not interfering with the carrier’s network or other users on the network

    • having a unique installation process to eliminate feedback into the mobile network.



Shipping Weight 11.0000kg
Shipping Width 2.400m
Shipping Height 0.420m
Shipping Length 0.460m
Shipping Cubic 0.463680m3