Cel Fi Go Repeater Kit designed for Regional Areas


Key Features


  • Complete package with an External Donor Antenna, Cabling, Cel Fi Go Repeater & a Wall Mounted Distribution Antenna

  • Full service for up to 20 Telstra mobile phones or modems

  • 4Gx(700MHz) or Next G(850MHz) frequency support (manual selection)

  • Suitable for Telstra, Boost, and Aldi Mobile networks

  • Currently Australia's only legal mobile phone repeater system.




  • The Cel Fi Go Repeater for the Telstra network is a convenient solution for those experiencing poor phone coverage within the house or office in regional locations

  • Installing this device in your home can improve the reliability of phone calls, text messages, and increase 3G or 4G or 4GX services

  • This is a complete repeater system designed to provide indoor or outdoor coverage

  • The dual-band 700-850MHz Yagi antenna is ideal for rural areas where long transmission distances are resulting in low signal, typically the tower is within 30-40km from your location

  • The repeater provides enough boost to create a 60m area of coverage within normal home or office environments - up to an impressive 100m area in open areas such as supermarkets or farms, as reported by our customers

  • Like all wireless systems, the coverage area is reduced by the signal travelling through thick walls or floors, so the actual coverage area will vary depending on your unique situation

  • Provides greater flexibility - we can split the output signal across multiple antennas and even daisy chain the set up down to another location. Please don’t hesitate to contact one of our sales team to discuss the potential options further


A heads up!


  • Provides 3G or 4G/x services to mobile devices - it cannot produce both networks concurrently

  • As this antenna does not operate on 1800MHz 4G, this kit is not suitable for urban areas.




  • The dual band Yagi antenna is connected to the repeater via a run of LCU400 cable with an SMA fitting, which allows the cable to directly connect to the Cel Fi Go’s input connector - from there, a smaller grade of LCU195 cable is connected to the Cel Fi Go’s output, which is run to the location where you want to install the ceiling mounted antenna.
  • Please note that the Distribution Antenna is directional with a 70°, so the antnena will only be able to provide coverage over an arc with little to no boosted cellular coverage existisng behind the Antenna 


Similar Kits


  • We provide similar kits for suburban and metro areas experiencing poor coverage indoors, despite having good signal outdoors - and kits with an upgraded 16dBi antenna for remote and outback areas.


Performance on 4G/4GX Internet


  • To provide the best possible and fastest Internet connection, a proper MIMO external antenna should be connected into a dedicated 3G/4G modem

  • Typical speeds through the repeater unit are around 25-30% of a dedicated modem.


Why is it legal?


  • Many mobile service providers do not  support the use of personal repeaters on their network. This is due to the interference they can cause when connected to the network, or when they are setup incorrectly

  • The Cel-Fi system is the only personal repeater that is widely approved by carriers in Australia

  • The Cel Fi Go is different to a standard repeater, as it is designed to provide maximum coverage, be network friendly and can be easily installed by the end user, it does this by:

    • continuously monitoring power levels of the cell tower it is connected to, constantly adjusting its output power to suit

    • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band

    • giving the service provider the ability to shut down the repeater remotely if needed, using a signal from the base station

    • not interfering with the carrier’s network or other users on the network

    • having a unique installation process to eliminate feedback into the mobile network.



Shipping Weight 11.0000kg
Shipping Width 1.600m
Shipping Height 0.220m
Shipping Length 0.250m
Shipping Cubic 0.088000000m3