Times Microwave LMR-400 Grounding Kit
- Mid-span framework grounding
- Outer conductor only.
This cable grounding kit is designed to provide a secure grounding point to the outer conductor of LMR400 cable using a mechanical clamping method. Cable runs should be attached to a good electrical ground at the top of the tower near the antenna, at the bottom of the tower, and at the point where the cable enters the transmitter building. If the tower is used as a broadcast radiator, only ground the cable at the first quarter wavelength point, (broadcast frequency) measured vertically from the base of the tower.
(1) Pre-formed tinned copper ground strap (1) ground lead assembly (2) ¼” brass lock washers (2) ¼” brass nuts (1) Roll 2-1/2” x 24” (610mm) butyl mastic (1) Roll ¾” x 20’ (6.1m) PVC tape (1) heat shrink tube (1) Field-crimp 3/8” 2-hole lug (2) 3/8” x 1-1/4” slotted bolts (2) 3/8” lock washers (2) 3/8” nuts (2) 3/8” flat washer
Important Stock Information This item is not always stored at our QLD warehouse, but is typically available within 24-48 hours from order.