Optus Cel Fi Go G32 Repeater Kit designed for Hilly Areas


Key Features


  • The Cel Fi Go G32 Repeater for the Optus network is a convenient solution for those experiencing poor phone coverage in the home or office

  • Complete package with an External Donor Antenna, Cabling, Cel Fi Go Repeater & a Wall Mounted Distribution Antenna

  • Full service for up to 20 Optus mobile phones &/or modems

  • Supported Frequencies - 3G: 900 or 2100MHz & 4G: 1800 or 2100 or 2600MHz (manual selection)

  • Suitable for Optus, Amaysim, Dodo, iiNet, plus more

  • Currently Australia's only legal mobile phone repeater system.




  • A complete repeater system for indoor coverage - can improve the reliability of phone calls, text messages and increase 3G or 4G services

  • The wideband 700-3000MHz LPDA antenna is ideal for areas with hills or dense vegetation causing low signal, where typically the tower is within 15km from your location

  • The repeater provides enough boost to create a 60m arc of coverage within normal home or office environments - up to an impressive 100m area in open areas such as supermarkets or farms, as reported by our customers

  • Like all wireless systems, the coverage area is reduced by the signal travelling through thick walls or floors, so the actual coverage area will vary depending on your unique situation

  • Provides greater flexibility - we can split the output signal across multiple antennas and even daisy chain the set up to another location. Please contact one of our sales team to discuss your options

  • Provides 3G & 4G services to mobile devices




  • The LPDA antenna is connected to the repeater via a run of LCU400 cable with an SMA fitting, which allows the cable to directly connect to the Cel Fi Go’s input connector - from there, a smaller grade of LCU195 cable is connected to the Cel Fi Go’s output, which is run to the location where you want to install the ceiling mounted antenna.

  • Please note that the Distribution Antenna is directional with a 70°, so the antnena will only be able to provide coverage over an arc with little to no boosted cellular coverage existisng behind the Antenna 



Similar kits

  • We also provide similar kits for suburban and metro areas suffering from poor coverage indoors, despite having good signal outdoors - and kits with an upgraded 14dBi antenna for rural areas.



Performance on 4G Internet

  • To provide the best and fastest Internet connection possible, a proper MIMO external antenna should be connected into a dedicated 3G/4G modem

  • Typical speeds through the repeater unit are around 25-30% of a dedicated modem.



Why is it legal?

  • Many mobile service providers do not support the use of personal repeaters on their network. This is due to the interference they can cause when connected to the network, or when they are setup incorrectly

  • The Cel-Fi system is the only personal repeater that is widely approved by carriers in Australia

  • The Cel Fi Go is different to a standard repeater, as it provides maximum coverage, is network friendly and easily installed by the end user - it does this by:

    • continuously monitoring the power levels of the cell tower it is connected to, constantly adjusting its output power to suit levels

    • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band

    • giving the service provider the ability to shut down the repeater remotely if needed, using a signal from the base station

    • not interfering with the carrier’s network or other users on the network

    • having a unique installation process to eliminate feedback into the mobile network.



A heads up!

  • Optus's Cel Fi Go2 will not boost the 4G+ regional network.





Shipping Weight 6.0000kg
Shipping Width 1.400m
Shipping Height 0.300m
Shipping Length 0.300m
Shipping Cubic 0.126000000m3