Ubiquiti NanoStation AC Loco Point-to-Point Wireless

 

Key Features

 

  • Connect two remote locations on the one network

  • Share Internet connection between buildings, remote sites, etc.

  • Up to 450+Mbps Throughput

  • Integrated AirOS web software for controlling power, bridge/AP mode, etc.

  • Two units required for wireless bridge

  • POE injector NOT included - POE-24-12W-G

 

What is a NanoStation Loco AC?

 

  • The Loco AC is a more cost effective version of the Ubiquiti NanoStation AC - it is a lower power unit designed for shorter distances

  • There are some features that the Loco version doesn't have, so if in doubt, please read through the specification sheet at the bottom of the page.

 

High Speed Point-to-Point Networking

 

  • Forget Ethernet cable, the Ubiquiti NanoStation Loco AC is ideal for bridging networks or sharing broadband between buildings

  • To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location

  • Face both units so they point towards each other and the link is established. Simple!

  • This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work

  • Management of the Ubiquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface.


Ready to Install

 

  • This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments

  • Signal strength indicators allow for quick and easy alignment

  • For best performance the unit should be roof mounted, high and clear of obstructions, via its integrated pole mounting bracket

  • The units are powered via Power over Ethernet (PoE) - but please note a PoE injector is NOT included with this product. 

  • This allows one cable to power the unit and also carry network traffic

  • We recommend using Cat6 Outdoor UV Shielded Cable with this unit.

 

A heads up!

 

  • Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors - model ETH‑SP- place one near the NanoStation and the other at the entry point to the building. The ETH‑SP will absorb power surges and safely discharge them into the ground.

 

Read More

 

 

(Loco5AC)

SKU Loco5AC
Brand Ubiquiti
Shipping Weight 0.6000kg
Shipping Width 0.210m
Shipping Height 0.600m
Shipping Length 0.110m
Shipping Cubic 0.013860m3